A simple car wash only removes topical dirt and filth acquired over short-run driving. Regardless how thorough the wash is, car wash soap will not deep clean, polish or restore the paint from damage completed by bonded contamination, embedded dirt and staining, and different types of below surface defects. Well-maintained and properly detailed cars are actually really the only cars that actually reap the benefits of a fundamental wash and use of a wax or sealant. The idea being that you have already experienced the process of decontamination (which is different from just washing) and either a mild polish, which deep cleans the paint to get rid of embedded dirt and stains or Auto Detailing in San Diego, which can completely remove oxidation and below surface paint defects (think restoration) and your paint just has to be maintained from a wash and wax or a maintenance detail.
There exists a crucial step between washing and polishing, which is referred to as Paint Decontamination. Paint Decontamination is actually a method that fails and removes bonded contaminants for example industrial fallout (another name for pollution), brake dust, rail dust, tree sap and tar that embed themselves to the top of the paint leaving the outer lining gritty and rough.
A simple way to check whether or not your car or truck is protected in bonded contamination is to try using the Baggie Test. All that you should do is place a sandwich baggie over your hand and feel your paint after washing. The plastic sandwich baggie enhances your feeling of touch and makes inspecting your paint easier. When your paint feels rough and gritty which means it’s contaminated. If your paint feels smooth as glass without having bumps or rough patches most probably it’s without any bonded contamination. If you want to read more about paint contamination read this detailed article: How Paint Contamination Works Against Your Car Or Truck & Paint.
When we went over previously, an easy polish will remove embedded dirt and stains from your paint but it’s not likely to remove or correct any paint defects like swirls, scratches, marring and etching. An entire polish will remove an extremely small percentage of your paint and also remove any below surface paint defects (oxidation, swirls, scratches, etching, etc.) which were only as deep as the volume of paint of paint removed.
Before & after removing embedded dirt and stains from a 2003 VW GTI. This vehicle was thoroughly washed and decontaminated before it received a mild polish, which removed all of the dirt you see around the right polishing pad. If no dirt or staining was embedded into the paint, the pad would of stayed white.
For instance, when you have a wooden tabletop that may be 3 inches thick and you accidently scratch the outer lining about 1 millimeter deep, it’s planning to leave an eye sore but it’s not deep enough to structurally damage the tabletop. So what on earth you might do get rid of the defect is sand the tabletop as a result of right beneath the deepest section of the scratch within the table. This would remove the scratch and restore your tabletop to top condition without harming the integrity in the table.
The same concept behind removing scratches from your wooden tabletop also applies to removing them from automotive paint. The goal of polishing paint is usually to remove as much or as a good deal of scratch, swirl or etch as possible without compromising the integrity of the paint. This is why I always approach a scenario by using the least aggressive method or product to do the job properly. I would like to leave all the of your paint around the car as you can in case it gets scratched again I will repeat the process safely and still have enough paint around the car to where it can be done several times again.
The perfect illustration of not selecting the right tool for the job is to try using a chain saw to cut the table by 50 % widthwise to remove the mirror surface scratch. You’ve drastically shortened the life span of your table as the right tool, product and technique were not properly chosen to match the circumstance at hand.
Now let’s suppose someone arrived in and hit your tabletop having an axe directly in the center. The harm was 2.5 inches deep and was in the contour of your “V”, meaning the particular bottom from the 2.5-inch pit includes a smaller width, than the top of the pit. Considering that the damage to the tabletop was so deep it’s impossible to get rid of the pit completely without also ruining the structural integrity in the table. It will not be thick enough to service its purpose of as being a table. While you can’t completely eliminate the pit from the tabletop through our previous way of sanding you could make it smaller and much less noticeable in the event you remove a number of the tabletop width but not enough to where it might loose it’s structural integrity. Ever since the pit is actually in the shape of a “V”, in order we remove width or material through the tabletop we are making the pit smaller and having the best looking table possible without compromising the integrity from the table because after the day you still want so as to utilize your table.
Deeper scratches in automotive paint work the same way. Generally, the scratch is a pit in the paint just like a pointy triangle (or “V”) and as you polish off paint in the surface you will be making that scratch smaller and smaller. The closer the top of the the paint is usually to the base of the pit the less noticeable the scratch will likely be. If you have a deep scratch it’s possible so it will be look significantly less noticeable with polishing, even though that scratch is not safe to completely remove.
50/50 both before and after one step of polishing. All minor scratches and swirls were removed and portions of the deeper scratch were removed or minimized. This kind of defect could of been safely removed 100% of how but the owner was not enthusiastic about that measure of correction for his work truck.
If you wish to take fixing the pit from the tabletop one step further you could fill it together with some kind of wood filler product, sand and stain the table again, which would fix the pit. This repaired area might or might not match the original staining or hue of the table for many reasons but it will be less noticeable and you also won’t have any kind of pits or surface defects within the tabletop. This procedure is comparable to fixing rock chips or deeper scratches in automotive paint, which require spot filling, painting, sanding, compounding and La Jolla Auto Detailing until the area is good as new or just like it can be.
In the event you can’t stand having any kind of defect or pit in your tabletop than you can always eliminate the legs from the table and buy another tabletop, which may be much like re-painting your vehicle. It’s by far the most expensive option nevertheless it will fix any and all paint defects.
The wooden tabletop analogy doesn’t work as well by using a light polish because it does with a full polish and other paint correction type processes but I’ll give you the general idea while using 62dexmpky analogy. If you spill a glass of milk on the wooden table and don’t wipe it all up completely it’s planning to penetrate the top of the tabletop as well as over time cause staining. Should you leave the spilt milk in your table for longer it may possibly begin to damage the wood by staining and degrading everywhere the milk was able to penetrate.
A mild polish would eliminate the embedded milk and topical staining however, not any one of the damage left from neglecting the stain and letting it deeply penetrate the table. It could improve the appearance of the table nevertheless it wouldn’t restore the table to its original condition as it now requires a full polish or maybe more to eliminate enough of the tabletop’s surface before the etching and staining is utterly removed.
An identical scenario is leaving bug guts or bird droppings in your vehicle to get a couple weeks or months. The organic matter in the bugs and bird poop will connect to your paint and permanently damage the area. If the area is cleaned over time the etching might be polished and removed, but sometimes it will probably be too deep and require you to re-paint the location or learn how to deal with the defects. To prevent this headache all together it’s smart to keep 2-3 towels plus a quick detailer in your truck so you can removed bird dropping as well as other harmful contamination at the earliest opportunity.